Hi,
Apologies if I have post on the board, I was not sure where to ask the question.
I have a Kickstarter 7020 board and I am using Win SCP and PUTTY to communicate with the board.
Andreas's recent fantastic announcement about the Epiphany-V 1024-core 64-bit RISC processor has spurred me to start experimenting with my board again!
I downloaded the above mentioned image, updated the files, used Suzanne J. Matthews excellant guide to expand to the full disk size and started looking at the files. When I tried to run some of the examples the ehal.h is missing kept cropping up, so I had a look for the SDK, assuming it needed to be installed. I tried to run setup.sh and got this error message :-
Please set the EPIPHANY_HOME to the root folder of the SDK release!
My Linux is rusty, so I looked this up online and altered the bashrc file, but this did not make a difference.
Old
export PATH=/usr/local/browndeer/bin:$PATH
export LD_LIBRARY_PATH=/usr/local/browndeer/lib:/usr/local/lib:$LD_LIBRARY_PATH
export PATH=/opt/openmpi/bin:$PATH
export LD_LIBRARY_PATH=/opt/openmpi/lib:$LD_LIBRARY_PATH
export EPIPHANY_HOME=/opt/adapteva/esdk
[ -e $EPIPHANY_HOME ] && . $EPIPHANY_HOME/setup.sh || echo Epiphany SDK not installed.
New
export PATH=/usr/local/browndeer/bin:$PATH
export LD_LIBRARY_PATH=/usr/local/browndeer/lib:/usr/local/lib:$LD_LIBRARY_PATH
export PATH=/opt/openmpi/bin:$PATH
export LD_LIBRARY_PATH=/opt/openmpi/lib:$LD_LIBRARY_PATH
export EPIPHANY_HOME=/opt/adapteva/esdk.2016.3.1
[ -e $EPIPHANY_HOME ] && . $EPIPHANY_HOME/setup.sh || echo Epiphany SDK not installed.
Questions
1. Is the SDK actually installed and if so what am I missing?
2. Have I amended the EPIPHANY_HOME variable correctly?
3. Is egcc installed? If not which folder should it be installed in?
4. If it is not installed, are there any instructions on installing egcc, the comment on github is a bit vague.
If someone could point me in the right direction, I would be very grateful!
Regards,
Paul