Green LED comes on and stays Solid with the power supply connected (USB hub/OTG cable seems to be working/powering a fan from usb)...
But now I am not able to see anything on the display (HDMI)...I had made an SD Card according to the setup guide (Ubuntu 14.04 Parallella with Zync 7010 GPIO/ FPGA with Win32 Disk Imager and then copied the files over)....but there is nothing at all displayed on my screen with the Parallella all plugged in, usb working, hdmi seems to be working and detected by my hdmi switch (turns off when I turn off the parallella like it should) but nothing is displayed on the actual monitor (I also tried a direct connection, just goes into power saving mode like nothing is connected) and the LED on the board stays solid green the entire time.
I do not have an ethernet router to plug into, only wireless..I do have a Panda Wifi adapter hooked up to the Parallella though...Statistics: Posted by carsenk — Tue Jul 08, 2014 10:53 pm
]]>