I'm new to the parallella world, just received the board today!
i found really useful the script because i started connecting via Win the board and cant use the graphic interface.
with the heatsink provided i recorded pretty high temp even with idle board - 76°C.
zynq temp up no fan.JPG
i found some interesting post using a 5v fan but i'm not confortable with soldering..
so i used an old small case fan - 12v - connected to the pc power.
temperature dropped to 55.7 °C at idle.
zynq temp up 12v fan.JPG
tomorrow i'll use an old 12v adapter from a notebook to make a dedicated power supply.
i'll also try the improved scripts.
sorry if i posted in the wrong place! noob deserve some patience
best regards.
FS.
Statistics: Posted by fsalerno74 — Fri Jul 03, 2015 9:09 pm
]]>
]]>
]]>
]]>
viewtopic.php?f=12&t=1156
Statistics: Posted by Dr.BeauWebber — Sat May 31, 2014 9:09 pm
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
Instructions:
1) create a shell script (example: ztemp.sh) and copy/paste the following code into it, then save it
$ vi ztemp.sh
2) make the script executable
$ chmod 755 ztemp.sh
3) to run the script from the directory where it is located
$ ./ztemp.sh
Example Output:
Zynq Temp: 62.8 C / 145.0 F
Code:
#!/bin/bash
raw=`cat /sys/bus/iio/devices/iio:device0/in_temp0_raw`
offset=`cat /sys/bus/iio/devices/iio:device0/in_temp0_offset`
scale=`cat /sys/bus/iio/devices/iio:device0/in_temp0_scale`
c_temp=`echo "scale=1;(($raw + $offset) * $scale) / 1000" | bc`
f_temp=`echo "scale=1;(($c_temp * 9) / 5) + 32" | bc`
echo
echo "Zynq Temp: $c_temp C / $f_temp F"
echo
Statistics: Posted by ubii — Wed Mar 05, 2014 6:18 am
]]>