1. Built sd card as per instructions (7010, headless, no hdmi).
2. Booted, found IP via dhcp table, logged on via ssh successfully.
3. sudo reboot, wait a couple of minutes.
4. system does not contact dhcp server, does not respond to ping or ssh at old address, and cannot be reached.
5. Power cycle... same result. Unreachable.
I've tried variations: different sd card, poweroff instead of reboot; same result.
Any idea why a first boot would be fine, but a reboot doesn't work? The orange ethernet light does blink intermittently.
Statistics: Posted by krovetz — Sat Nov 01, 2014 11:13 pm
]]>
the response of your board remind me to the first try of boot, then i re download from github the boot files re-decompress and re-copy to the sd card, then everything works fine before i put the hand on it
this are the official place where you should be able to retrive everything you need:
https://github.com/parallella/
http://downloads.parallella.org/
Statistics: Posted by adexmont — Thu Sep 04, 2014 2:36 pm
]]>
1. I followed the steps mentioned in http://www.parallella.org/create-sdcard/ to create the sd card. After that I checked the BOOT section of the micro-SD card and it seems its fine.
2. Connect the wires mentioned in http://www.parallella.org/quick-start/ ..
Remark: I connect to the power source and also connect to the laptop via the USB (micro-USB-male). I did not use powered- usb hubs to connect mouse, keyboard etc.
BUT
What error I am getting:
1. NO HDMI signal
2. No orange light is ON only the green light (next to Ethernet cable) is ON. <Does it mean the system is booting??>
3. But the other two green lights are ON.
The board is touched many times does it damage the board? How to know it is damaged?
In the manual its written that there is a RESET BUTTON, PLEASE tell me where it is as I did not find that on the board.
Please help..
Statistics: Posted by sommaz — Thu Sep 04, 2014 11:36 am
]]>
1) Download Ubuntu http://www.parallella.org/create-sdcard/ as instructed in the page
2) Download Kernel as instructed in the page above
3) This is where I was making a mistake. My board has Zynq 7010 Chip instead Zynq 7020 and I kept getting the 7020 version for my board thats why it didn't work. Check your board code. My is P1601-DK03 and I check the Parallella Board Version History http://www.parallella.org/boardhistory/ It said Z7010
The rest of the instruction is basically the same.
After 2 frustrating days trying to make it work. Now I'm relief knowing the board is working
Statistics: Posted by teekai — Sat Aug 09, 2014 9:05 am
]]>
Tried with HDMI got NO HDMI output signal and NO NETWORK connection
Tried the HEADLESS then I was able to get Network Connection. The green light is solid and orange light blink sometime. Verify with the router, it is there in the DHCP table and I was able to PING it but can't SSH login
I got the version of board with large HEATSINK but it got finger burning hot after leaving it about 2h on while I tried to image my other sd card.
It seem harder to get everything working properly than it looks
Statistics: Posted by teekai — Sat Aug 09, 2014 7:53 am
]]>
]]>
]]>
]]>
]]>
]]>