So I just purchased the Parallella Cluster kit, which contains 4 Parallella boards.
Has anyone found a conventional way to create some enclosure for more than just 1 of these?
Also, does anyone know the exact dimensions of the board, as far as where the mounting holes are that can be used to stack the boards?
I found this: http://www.seeedstudio.com/depot/sick-o ... Path=55_60 and was hoping I could order a few of those, but id need to know the exact distances and sizes of the mounting holes on the parallella board that are used to stack them in this picture: http://www.parallella.org/wp-content/up ... 24x768.jpg
I think this one should fit, can anyone tell me for sure? http://www.parallella.org/wp-content/up ... 24x768.jpg
Case/Enclosure for Cluster?
by jhyland » Tue Sep 03, 2013 8:05 am
Last edited by jhyland on Tue Sep 03, 2013 9:54 am, edited 2 times in total.
- jhyland
- Posts: 9
- Joined: Mon Aug 19, 2013 8:43 pm
