Parallella Community

Hi,

I have a parallella board, and I know that the Serial port come by default as a terminal, actually I can talk with my parallela via UART without problems.

However, I have a motion sensor and a wish to connect it to the parallela via UART, but I can't because is a console terminal.

Someone tried to disable the console TTPS0 and turn it as a standard serial port?
I don't know if it's a config issue, or I need to modify something else.

Thank you for you attention and comments.

Best regards

Luis

Thank you people, you are amazing.

Now the TTYPS0 works as a standard serial port.

FHuettig, you were right.


Regards

Luis