Clarifiation regarding PEC_GPIO connector in parallella Mirc

Any technical questions about the Epiphany chip and Parallella HW Platform.

Moderator: aolofsson

Clarifiation regarding PEC_GPIO connector in parallella Mirc

Postby maneesh » Sun Dec 18, 2016 11:57 am

I am planning to use parallella for a low cost Instrument
design,I need atleast 24 GPIOs and HDMI.
I was considering to use the microserver as it fits into my cost
limitations.
In the microserver there is no PEC_GPIO connector,But the other models
like Desktop and Embedded are expensive and they will fail my model of low
cost instrumentation.
So,i gone through the schamitcs of the microserver boards,i can see that
there are PEC_GPIO and HDMI soldered connections out but there is no connector?
So,can i buy SAMTEC BSH-030-01-F-D-A and HDMI connector seperately and place it at that
location?
will the GPIO and HDMI work? or in case of microserver there is no connections from
Zynq to the bottom side of the board.
please clarify
maneesh
 
Posts: 1
Joined: Sun Dec 18, 2016 11:53 am

Re: Clarifiation regarding PEC_GPIO connector in parallella

Postby aolofsson » Sun Dec 18, 2016 9:14 pm

Theoretically, you could solder on samtec connectors on the microserver...
User avatar
aolofsson
 
Posts: 1005
Joined: Tue Dec 11, 2012 6:59 pm
Location: Lexington, Massachusetts,USA


Return to Epiphany and Parallella Q & A

Who is online

Users browsing this forum: No registered users and 1 guest

cron