Page 8 of 8

Re: Show your Parallella!!

PostPosted: Thu Oct 30, 2014 6:29 pm
by greytery
Neat!

All fans have a 'dead spot' immediately in front of the motor hub.
The main 'heat spot' on the Parallella comes from the Zynq (although other chips get warm too).
Going by your picture, it looks like the 'dead spot' is positioned over the Zynq 'heat spot'.
Likely that under the hub there is very little air-flow - just where you need it most!

Suggest you put a spacer between the fan and the sink, maybe 1-2 cm longer screws, so that you get the air-flow.
Perhaps not so neat - but probably lower temp.

Cheers

48-node parallela cluster

PostPosted: Mon Aug 10, 2015 2:16 am
by ykx
1U , 600W power , with 48 node.

Re: Show your Parallella!!

PostPosted: Mon Mar 07, 2016 12:27 pm
by hukuzatuna
I'm new to the Parallella community, but here's my new "desktop," a little four-board cluster.

Cheers,
Phil

Re: Show your Parallella!!

PostPosted: Sun Feb 19, 2017 2:13 pm
by eleitl
I've recently resurrected my Kickstarter board (it only had a popped out flash card, whew) and upgraded it to Paraubuntu.

Here is my ghetto Lego case (my son helped) for it.

epiphany-lego2.jpg
Ghetto Lego case
epiphany-lego2.jpg (156.84 KiB) Viewed 5740 times