Camera connection

Camera connection

Postby zodane » Thu Nov 13, 2014 7:19 pm

Hello every one,

I need to connect a camera to the FPGA zynq wich port should i use
I dont want to use PORT
Is there a I2C port (ready to use) in the parallella?
Is there any one here that have connect a HD camera
Where can i fond a H.264 compression for a parallella
:geek:
Regards
Last edited by zodane on Fri Feb 13, 2015 10:26 am, edited 1 time in total.
zodane
 
Posts: 26
Joined: Mon Nov 10, 2014 8:45 pm

Re: Camera connection

Postby 9600 » Thu Nov 13, 2014 10:11 pm

The quickest/easiest solution would obviously be to connect a USB camera, or to stream video to the board from some other source, e.g. as was done some time ago with an Erlang project that used multiple cameras.

http://www.parallella.org/2013/09/10/ex ... th-pixels/

I2C is brought out to the PEC_POWER expansion connector. If you wanted a fast, low latency interface you could implement this in the FPGA, interfacing with the ARM host via AXI and with the physical connection via the PEC_FPGA connector.

Regards,

Andrew
Andrew Back (a.k.a. 9600 / carrierdetect)
User avatar
9600
 
Posts: 997
Joined: Mon Dec 17, 2012 3:25 am

Re: Camera connection

Postby zodane » Fri Nov 14, 2014 3:08 pm

thank you
zodane
 
Posts: 26
Joined: Mon Nov 10, 2014 8:45 pm


Return to Image and Video Processing

Who is online

Users browsing this forum: No registered users and 1 guest

cron