Parallella Community

Hello every one,

I need to connect a camera to the FPGA zynq wich port should i use
I dont want to use PORT
Is there a I2C port (ready to use) in the parallella?
Is there any one here that have connect a HD camera
Where can i fond a H.264 compression for a parallella

Regards

The quickest/easiest solution would obviously be to connect a USB camera, or to stream video to the board from some other source, e.g. as was done some time ago with an Erlang project that used multiple cameras.

http://www.parallella.org/2013/09/10/ex ... th-pixels/

I2C is brought out to the PEC_POWER expansion connector. If you wanted a fast, low latency interface you could implement this in the FPGA, interfacing with the ARM host via AXI and with the physical connection via the PEC_FPGA connector.

Regards,

Andrew

thank you