Parallella Community

I recently purchased two orders of 18 core parallella boards, one order of 2 boards and one of 6 boards. I planned to connect these using a jumper for J15 and then powering two stacks of 4 boards each. I managed to get 7 of the 8 boards working, but the last board even after jumping shows infinite resistance between the negative and positive power pads. I also tried to power the board via a 2A micro USB cable and I wasn't able to get the power LED to light. I unfortunately do not have a barrel connector in 5V anywhere near 2A. I noticed that the barrel connector leg (when looking at the barrel connector head on) on the right side of the barrel shows a complete circuit with the negative power pad. I just purchased a barrel connector power supply and should have it Tuesday... but if that works I was planning to just drop a bead of solder between the right leg of the barrel connector and the positive power pad, what do you guys think? Can I have someone confirm that the right leg is the positive leg?

EDIT:

Looks like I posted this too soon, I found that you need to switch the power source jumper from the first position to the second to allow for USB powering... so I will try this and see if that does the trick for the USB power issue.

Hard to comment regarding "the right leg", not sure what that means. Let us know how it goes.
Thanks,
Andreas

I tried powering the unit via a 2A USB connection as well, with the power source jumper in positions 1 and 2, and unfortunately the power led is not lighting. I will try the barrel connector when I receive it.

Got the barrel connector power supply last night and tried to power the board, but no luck. Any ideas as to what I can try next, or is it possible this board is dead?