Possible board manufacture fault

Hardware related problems and workarounds

Possible board manufacture fault

Postby rezaa_mir » Fri Aug 01, 2014 9:38 pm

Hi

I just received my new parallella board.

But noticed a patch of solder has connected the two of pins of the Marvell PHY chip (i think pin 10, 11) on the top side of board.

I am concerned to power up the board and cause damage, I can send the pic of board if you need it

Cheers
RM
rezaa_mir
 
Posts: 1
Joined: Fri Aug 01, 2014 9:24 pm

Re: Possible board manufacture fault

Postby aolofsson » Sun Aug 03, 2014 5:01 pm

Can you post a pick of the pins in question. If correct, this is information we will feed back to our manufacturer immediately.
Thank you!
Andreas
User avatar
aolofsson
 
Posts: 1005
Joined: Tue Dec 11, 2012 6:59 pm
Location: Lexington, Massachusetts,USA


Return to Troubleshooting

Who is online

Users browsing this forum: No registered users and 15 guests

cron