Page 1 of 1

no device detected using jtag

PostPosted: Thu May 31, 2018 11:32 am
by parallella-project
I've create a new parallella project in Vivado by using this project:
https://github.com/parallella/parallell ... o/releases

one thing is that when I run the project the status changes to "route_design complete, Failed Timing!". I don't know if it's related to my problem.
the main problem here is that when I'm trying to "open hardware manager" and "open hardware target" and and "connect to local server" there is nothing in the hardware devices! (there is a "xilinx_tcf" in hardware targets)
So what should I do?
I'm using xilinx JTAG programmer and connected through the porcupine board.

Re: no device detected using jtag

PostPosted: Fri Jun 08, 2018 2:15 pm
by olajep
Might be a permissions problem:
https://www.xilinx.com/support/answers/66440.html

// Ola